Installation And Setup; To Insert And Remove The Battery; Battery Life; Two Colour Led - Petsafe PBC19-11794 Manual De Funcionamiento

Installation and Setup

The PetSafe Outdoor Bark Control should be placed facing the dog and within range
®
of the dog. The unit is designed with provisions for hanging or mounting and should be
positioned at a height of no more than 1.5 metres (5 feet). The Outdoor Bark Control can
also stand alone. It can be placed in a tree, hanging from a pole, on a fence post, etc. For
best results, the area between the Outdoor Bark Control and the dog should be free of any
large obstacles.
__________________________________________________________

To Insert and Remove the Battery

1. The PetSafe Outdoor Bark Control utilizes a replaceable 9-volt battery (not included).
The battery door is located on the back of the unit. Lift the battery door open.
2. Insert the 9-volt battery with the positive side oriented as shown.
3. Replace the battery door by positioning the top edge, and snap the bottom of battery door
into place.
Lift Battery Door
6
Replace
Battery Door
Top End First
petsafe.com

Battery Life

Average battery life is 2 months, depending on how often the dog barks. To conserve battery
life, turn to the "OFF" position when the Outdoor Bark Control is not in use.
__________________________________________________________

Two Colour LED

The two colour LED indicator shows good or low battery. Good battery equals 1 flash every
5 seconds with Green LED. Low battery equals 3 flashes every 5 seconds with the Red LED.
If there are no LED lights it is time to change the battery. When emitting the ultrasonic
sound, the Red LED is solid. When in test mode, the Red LED will flash if battery is low.
__________________________________________________________

Modes of Operation

• Begin use of the Outdoor Bark Control on the Low Range setting and only increase to the
Medium Range setting if the dog does not respond.
• If the dog does not respond to the Medium Range, increase to High Range.
• Turn to the TEST Mode to verify that your Outdoor Bark Control is working properly. Do
not use this Mode for normal operation. See "To Test the Outdoor Bark Control."
Sensitivity Setting Range
Low Up to 4.6 metres (15 feet)
Medium Up to 9 metres (30 feet)
High Up to 15 metres (50 feet)
__________________________________________________________
What to Expect During Use of the
Outdoor Bark Control
Place the PetSafe Outdoor Bark Control within range of the dog with the unit switched
®
to Low, Medium or High. Most dogs will understand very quickly that the Outdoor Bark
Control is disrupting their urge to bark and will relax and stop barking.
You should notice a reduction in the dog's barking within the first two weeks that the
Outdoor Bark Control is in use.
petsafe.com 7