Operation; Fault Identification And Troubleshooting; Personal Protective Equipment - IBS Scherer Typ A Manual De Instrucciones

∙ Connect the mains plug (7) to the 230 V socket. If the place of use is further away, use a reliable extension cable.
∙ Perform a function test.

6.2.2. Operation

∙ Position the device under the vehicle or suspension part to be cleaned.
∙ Turn on the device main switch (rocker switch).
∙ Press the on / off mechanism and clean the vehicle or suspension part with the brush.
∙ By releasing the on / off mechanism, the pump turns off.
∙ Turn on the device main switch.
NOTE
Please complete the warranty card (form) which you will find at www.ibs-scherer.com.
6.3. Fault identification and troubleshooting
Fault
Pump not working
Pump not working
If the steps described above do not resolve the problem please call 0049-67 01-93 83 -0 or contact us per e-mail at info@ibs-scherer.com.
6.4. Personal protective equipment
When handling cleaning agents, protective clothing must be worn in accordance with the safety data sheet for the industrial cleaner used.
Solvent-resistant gloves, safety glasses and aprons must be used with all IBS-Special Cleaning Agents.
Glove material:
∙ Gloves made from polychloroprene (CR), recommended material thickness: > 0.5 mm, max. breakthrough time: 4 hours
∙ Gloves made from nitrile rubber / nitrile latex (NBR), recommended material thickness: > 0.35 mm
∙ Gloves made from fluororubber (Viton) (FKM), recommended material thickness: > 0.4 mm
∙ Permeation rate / breakthrough time: > 8 hours (EN 374)
The exact breakthrough time must be ascertained from the protective glove manufacturer and must be observed. Protective gloves should
be replaced when they show the first signs of wear.
Cause
No power
Pump is faulty
Liquid level in drum is too low
Pump is faulty
Solution
Check that mains plug is plugged in
Replace pump
Check liquid level, if necessary ask IBS Scherer to change
the drum
Replace pump
IBS-BA_Typ_A-DE_CZ_PL_ES_EN_04.2020
EN
49