Magenta MARGULES ARCH-3 Manual De Instrucciones página 12

• Wiring: Cables running inside walls should
have the appropriate markings to indicate compliance
and listing by the UL, CSA or other standards required
by the UL, CSA, NEC or your local building code.
Questions about cables inside of walls should be
referred to a qualified custom installer, a licensed
electrician, or low-voltage contractor.
18. RECORDING COPYRIGHT: Recording of
copyrighted material for other than personal use is
illegal without permission of the copyright holder.
19. NOTE TO CATV SYSTEM INSTALLER: This
reminder is provided to call the CATV system install-
er's attention to article 820-40 of the NEC, ANSI/NFPA
70, which provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building
as close to the point of cable entry as practical.
20. FCC INFORMATION FOR USER:
• CAUTION: A n y c h a n g e s o r
modifications not expressly approved
by Margules Audio could void the user's
authority to operate the equipment.
• These limits are designed to provide reason-
able protection against harmful interference in a
residential installation. This equipment generates and
can radiate radio frequency energy, and if not installed
and used in accordance with the instructions it may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the follow-
ing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
Connect the equipment into an outlet on a circuit
different from where the receiver is connected.
21. OUTDOOR ANTENNA INSTALLATION/SAFE
ANTENNA AND CABLE CONNECTION:
• If an outside antenna or cable system is
connected to the equipment, be sure the antenna or
cable system is grounded in order to provide protec-
tion against built-up static charges and voltage
surges. Article 810 of the National Electrical Code,
ANSI/NFPA 70 (in Canada, Part 1 of the Canadian
Electrical Code) provides information regarding proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of anten-
na discharge unit, connection to grounding electrodes
and requirements for the grounding electrode.
• Outside antenna system should be located well
away from power lines, electric light or power circuits
and where it will never come into contact with these
power sources if it should happen to fall. When install-
ing an outside antenna, extreme care should be taken
to avoid touching power lines, circuits or other power
sources as this could be fatal. Because of the hazards
involved, antenna installation should be left to a
professional.
ENGLISH - 11