Installing Memory Card; Battery And Charging - Panacom MP-1124 Manual De Usuario

Installing memory card

Since the mobile phone doesn't have enough space, you may
need to install a memory card (SD card).
To install the SD card: open the rear cover, take out the battery,
M insert the SD card into the slot, install the battery and then turn
on the mobile phone.
To remove the SD card: open the buckle and take out the SD
card, and then lock the buckle.
Note: SD card is tiny. Please keep it away from children. Please
ace select qualified SD cards, such as SANDISK, V-DATA, and
Transcend. Please match with the mobile phone when you
M purchase the card.

Battery and charging

Installing the battery
Only use qualified battery and accessories. When the battery
r isn't used, put it in the protective case.
ions Note: Please operate according to the instructions to avoid
damaging the battery contact.
Charging the battery
ort
The new battery will reach its optimized performance after
complete charging and discharging for several times.
your Please charge in time when the battery voltage is low. Over
e discharging will damage the battery. Disconnect the charger
ar from the AC power supply and the mobile phone after
charging. While charging, the battery status icon flashes from
n right to left, and stops flashing after charging. It is normal that
the battery becomes warm in the charging process.
Battery status
Your mobile phone can monitor and display the battery status.
your 1> You can check the battery status from the icon in the upper
Pg. 7