Maintenance And Cleaning - Metria YPZ Serie Manual De Instrucciones

ALWAYS MAKE SURE YOU CALIBRATE YOUR SCALE BEFORE USING,
FEATURES
•
High precision load cell
•
Rugged plastic housing
•
LCD display
•
Height-adjustable feet
•
Overload protection
•
Checking weighing,piece counting function
•
RS232 Interface
YPZ Models • All Rights Reserved •
• www.labbox.com
II. Maintenance and Cleaning
To get the best results and for product longevity, be sure to follow the
suggestions below
.
Note: All of the suggestions and guidelines mentioned below and through- out
this manual will only be effective with continuous and careful maintenance of
the equipment
•
Follow all processes outlined in the manual
•
Make the manual available to all users of the equipment
•
Prevent the balance from any sudden movements or falls, as well as
from direct sunlight or air flow. The balance is a precision instrument
and must be handled carefully.
•
Balance must be plugged into a grounded electrical outlet and the
socket should be easily accessible to unplug in case of emergency
•
Never unplug the balance by pulling on the wire, do so from the base
•
Never use the balance in a wedged-in location, such as a shelf
•
Never use other objects such as pens, pencils, etc. to press the but-
tons on the control panel; use only your fingers.
•
Never place anything on the pan heavier than the maximum capacity
of the balance, or the sensor could be damaged
•
Do not submerge the balance, nor spill any liquids on it
•
If any liquid does come into contact with the electrical parts of the
balance, immediately disconnect it and send it in for service to be
checked and adjusted if necessary
•
Always use only original components and supplies. Other devices and
parts may appear similar, but can damage the equipment.
Cleaning
•
Never use scourers or substances that can grate to clean metallic parts. This
include, but is not limited to, stainless steel, aluminum, coatings, etc.. These can
damage the balance and lead to early erosion of effectiveness of the balance.
•
-Use a lint-free cloth, dampened with soapy water, that does not contain any
abrasive surfaces, nor corrosive materials
ATTENTION!! If equipment is not properly
cleaned and cared for, technical service will
be unable to fix or repair issues.
YPZ Models • All Rights Reserved •
• www.labbox.com