GAPOSA SZX Istrucciones página 12

WARNING: The door, when moved manually through one of the 4 above mentioned devices, must never overcome the up or down limit
switches otherwise the door risks to be damaged and the limit overcoming activates the safety switches with the result that electrical operation
will then be possible only after the intervention of a technician disabling the protection.
7.1 MANUAL OVERRIDE WITH CHAIN
To manually activate the shutter with the manual
override with chain you must:
1. Pull the red knob and simultaneously the chain
until the override engages the motor shaft
and stops, through the safety micro, the power
supply.
2. Manually lift or lower the shutter by means of the
chain.
WARNING: handle the chain uniformly without
tugging.
3. When the manual override is accomplished, pull
the green knob to turn the power supply on.
WARNING: Check that the safety override is unlocked otherwise the motor cannot be activa-
ted electrically.
7.4 HANDLE WITH HOOK
To manually operate the shutter by means of the handle with hook proceed as follows:
1. Insert the hook into the eyelet.
2. Pull downwards the hook by turning the rod in the two directions until the override engages the motor
shaft and stops through the safety micro, the power supply.
3. Continue to pull the rod with hook downwards and turn it clockwise or counter-clockwise to open or
close the shutter.
4. Once the emergency operation is accomplished, release the rod in order to give power supply again to
the system and remove the hook from the eyelet.
12
7.2 MANUAL DECLUTCH
To manually operate the shutter you must:
1. pull the red knob, the lever disengages the
motor gear from the drive shaft and stops the
power supply through the safety micro.
2. manually lift or lower the shutter.
3. Once the emergency operation is accompli-
shed, pull the green knob in order to give
power supply again to the system.
7.3 STANDARD HANDLE
To manually operate the shutter by means of the han-
dle proceed as follows:
1. insert the handle into the back of the motor and
turn it until it engages the motor shaft;
N.B.: While introducing it, a safety micro will turn the
power supply off.
2. Turn the handle clockwise to open the shutter or
anticlockwise to close it.
3. Once the manual operation is accomplished remove
the handle.
90° installation possible