Product Appearance - Blaupunkt VIO-H30 Manual Del Usuario

2. Product Appearance

Please refer to the following sheet for more details about each port.
SN
1
2
3
4
5
6
7
Note:
To perform a factory reset press the reset/WPS button
turns off and the red Indicator light turns on and starts flashing. Now wait until the Green Indicator
light flashes slowly. Now the camera is reverted to default settings.
For advanced users who want to configure by WPS instead of the recommended WIFI or Ethernet
configuration, please refer to Web Interface manual. To download the Web Interface manual, please visit our
website http://security.blaupunkt-service.com
Please refer to the following sheet for more details about status of indicator light.
Indicator light status
Red light normally on
Green light slow flashing
Green light quick flashing
Green light normally on
Red and green lights flash
alternately
Red light slow flashing
Red light quick flashing
Name
USB power supply
Reset/ WPS button
Micro SD Card Slot
Speaker
Lens
Indicator light
Microphone
Device status
Booting
Booting completed, await wifi config, enter smart config
status;
Wifi smart config in progress, including WPS (Wi-Fi
Protected Setup), management frame and etc.
Wifi connection succeeded, operate normally.
Device upgrade
Network connection failure or disconnection after
network connection success.
Device malfunction, fail to boot up; alarm or SD card
malfunction
for 15 seconds until the green Indicator light
3