Steren HER-201 Manual De Instrucciones página 18

1. Mark the work to be done, the supplied
stencils can assist with this (they are not
designed to be used with the tools directly).
2. Use a mask or guide to prevent damage
to surrounding areas.
3. Hold the grinder firmly and switch on, test
the tool against the surface to check action
before beginning work.
4. Complete the work in stages, do not
apply excess pressure or cause the tool to
slow down.
Engraving
Hold the HER-201 mini grinder so that it is close to
vertical and move at an even pace with a steady
pressure.
Pauses and alterations in pressure will be
noticeable.
Use a straight edge where possible.
Try printing a sticky label with your lettering on it.
Stick onto the item to be engraved and trace the
outline.
7 7