Cup Seal Removal Guide - Spyder Sonix&Sonix PRO Manual De Instrucciones

CUP SEAL REMOVAL
VRT023
VRT025
FRG007
FRG025
The following steps will provide easy access to the Cup Seal (#ITP012). The sign of a worn out Cup Seal is the
presence of CO2 / Compressed Air leaking down the barrel.
STEP 1 Loosen both C/A Adapter Screws (#SCR019) from the C/A Adapter (#ASA007 or #ASA025).
STEP 2 Loosen the Vertical Screw M5x12 (#SCR016).
STEP 3 Remove the Vertical Adapter (#VRT023 or #VRT025) and Fore Grip Handle (#FRG007 or #FRG025) out
the front of the Receiver (#REC023 or #REC025).
STEP 4 Once the Vertical Adapter has been removed the Valve Spring (#SPR006) Valve Pin (#ITP013) Cup Seal
Guide (#ITP011) and Cup Seal (#ITP012) would be attached with the Vertical Adapter.
STEP 5 Detach the Valve Spring from the Vertical Adapter, and then unscrew the Cup Seal from the Valve Pin.
Replace the Cup Seal with a new one supplied in the Spare Parts Kit.
Once these steps have been completed, replace the damaged Cup Seal and reassembly all parts back in the Receiver.
HELPFUL TIP: Please note how the parts are removed for easy reassembly.
CAUTION: Use the proper Allen wrenches to fasten all screws and never apply more force than necessary.
IMPORTANT: Always remove the Air Tank before any disassembly of your marker. Do not remove the Valve Body
(#ITP014) unless specific Valve Body repairs are needed. Do not remove the Valve Body with a screwdriver as it will
damage the Valve Body Lip and cause air leaks.
prior to taking out the Valve Body.
7
REC023
REC025
ITP012
ITP013
ITP011
SPR006
ASA007
ASA025
SCR019
NOTE: The Valve Body Screw (#SCR015) screw must be removed
SCR016