Machine Use - Toparc 058866 Manual De Instrucciones

PARTS OF MACHINE
1 - Plane support
2 - Vacuum cleaner frame
3 - Handle
4 - Supply valve
5 - pneumatic tool plug
6 - Hook
INSTALLATION OF MACHINE
Place the machine on a stable and level surface. Verify that it is possible to connect the metal suction cleaner pliers to
the grounding system of the working area.
Connect the suction cleaner to the pneumatic sleeve supplied (see figure 3) with the machine and connect:
- The quick coupling to the pneumatic sleeve on the front right side of the suction cleaner
- The suction head to the pipe union of the suction cleaner
Disconnect the supply pipe from the vacuum head using the quick fitting, then remove the vacuum head using the two
metal hooks (see figure 4-5).
Place the dust bag inside the drum and firmly fix it to the sleeve (see figure 6).Place the vacuum head in the correct
position above the drum and fix it using the metal hooks supplied.
Connection to the pneumatic supply
Please note: use filtered and dry air only.
Verify that the supply faucet of the suction cleaner is closed.
Connect the supply faucet to a pipe with an internal diameter of 10 mm (see figure 7).
Adjust the supply pressure at 6.5 bar.Connect the pneumatic tool to the fitting on the sleeve and the suction pipe to
the socket on the pneumatic tool.
Warning, in order to function properly, the vacuum cleaner requires 1500l/min compressed air supply at a
pressure of 6bar. Make sure that the compressed air network is able to feed correctly the unit.
Connection to the grounding system
Connect the metal pliers to a part of the area that is connected to the grounding system of the plant. (see
figure 9)
CAUTION: ALWAYS connect the machine to the grounding system of the plant using the metal pliers, spe-
cifically during the use of the suction cleaner, the emptying of the dust bag and its replacement.
Check the tool functioning as indicated on their instructions manual.
Preliminary checks
- Check that the dust collection bag has been fitted in the container and that the filters have been fitted on the head;
- check that the vacuum hose is properly fixed and does not hinder tool movement;
- check that there are no leaks in the compressed air supply system.

MACHINE USE

The machine can operates in manual or automatic mode: to select the mode, turn the switch to the right (automatic
mode) or to the left (manual mode) (pic. 10).
Using the machine in automatic mode (A)
Automatic operations means that the vacuum starts when an electrical or pneumatic tool is turned on.
The vacuum will automatically turn off after the tool is turned off.
Using the machine in manual mode (M)
Manual operations means that the vacuum runs continuously.
Power on the front panel outlet socket is permanently active during manual running.
Professional pneumatic vacuum cleaner
7 - Grounding pliers
8 - Filter
9 - Dust bag
10 - Suction connection
11 - Castor wheels
12 - Supply compressed air inlet
EN
9