Cold Laminating - BLACK&DECKER LAM95 Manual De Instrucciones

2. Center your item in the open pouch, with the top edge of your
Laminating
Pouch
item towards the sealed seam of the pouch. Ensure there's a
minimum border of 1/8" on all sides of the item.
NOTE: If using Black & Decker TimeShield™ laminating pouches,
use the convenient positioning chart located on the back of each
package to ensure proper alignment and even borders.
1. Turn the laminator on by pressing the power button on the
control panel. The unit will automatically start in cold mode, with
the COLD button steadily lit.
2. Follow the instructions included with your self-adhesive
laminating pouches to position and inititally seal the item within
the pouch.
3. Insert the sealed end of the pouch straight into the in-feed slot
and gently guide forward until the machine pulls it through.
4. The pouch will automatically feed through the laminator and
exit through the rear. You can remove the laminated item once it
has stopped moving.
A B

COLD LAMINATING

5. In the event of a misfeed:
• LAM95: Pull jam release lever and remove
• LAM95FH, LAM125FH: Press and hold the
5
item through the front in-feed slot.
(See figure B)
reverse (REV) button on the control
panel while removing the item
through the front in-feed slot.
(See figure A)