Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9.
Set the DIP switch
No. 2
ON
and
in the
position.
The tilting limits have now been set.
*If you made a mistake and pressed the stop button when the carriers were not in the desired
position, you can readjust their position with the direction buttons as long as you don't release the
button that you have pressed on the motor.
IMPORTANT:
Secure the motor settings by covering the
Optional functions
•
Modifiying the direction of the slats
•
Adding a new remote control
•
Resetting the motor to factory default
Modifiying the traversing direction of the slats
This function is convenient when it is needed to change the traversing direction of the slats. This is
accomplished when pressing the
the
down
button, the blind opens.
1.
Press and hold the
wall control at the same time until the blue light
on the wall control flashes.
Adding a new remote control
The wall control can be used in order to add a new remote control.
1.
Using the wall control, press and hold the
button
5 s
for about
until the blue light on the
wall control flashes.
2.
Then, using the new remote control, select the
desired channel using the
button, and press the
remote control. Your
Vertilux
with the new remote control.
No. 4
in the
OFF
position
limit setting buttons
up button
up
and
down buttons
on the
channel selector
up button
of the new
blind is now paired
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
with their cover.
on the wall control, the blind closes, or when pressing
stop
WALL CONTROL
NEW REMOTE
CONTROL
1
2 3 4
DIP
ON
UP & DOWN
BUTTONS
STOP
BUTTON
BUTTON
vertilux.com
UP
7
Publicidad
Tabla de contenido
