Light Kit Assembly - Craftsman BL52-LED Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Light Kit Assembly.

Remove 1 screw from motor plate (on underside
of motor housing) and partially loosen the other
2 screws.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLACK
(or BLUE) wire from motor housing to BLACK
wire from LED light kit. Be sure molex
connections snap together securely.
Align slotted holes in LED light kit with loosened
screws in motor plate. Carefully arrange wiring
within space in LED light kit so that wires remain
completely inside LED light kit. Twist LED light
kit to lock. Re-insert screw that was previously
removed and secure all 3 screws with a Phillips
screwdriver.
Align slots on glass shade with nodules on
underside of LED light kit.
glass shade and turn glass shade
(clockwise)
until it slides completely into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
11. Assembly of Handheld Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 11
for remote control assembly instructions. If you
have already installed the wall control but do not
wish to use the handheld remote control, please
proceed to Section 12.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
Since this fan comes with LED light kit, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (ON). [Refer to
diagram 2.]
["Assembly of Handheld Remote Control"
continued on next page.]
Push up gently on
to the RIGHT
LED light kit
glass shade
diagram 1
diagram 2
page 9
motor plate
molex
connections
slots
remote control
cover
(top)
(bottom)
wall control
dimmer
wire
switch
-
1 1
-
2 2
DIM ON
wire
wire
12V battery

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido