Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Locate the factory installed middle body mount bracket, and remove (2) nuts from existing mounting studs as indicated.
4
Install middle bracket over existing mounting studs, and secure by reinstalling the (2) previously removed nuts. Hand
Middle bracket
5
Align the driver side nerf bar with the driver side front
mounting bracket and loosely attach using (2) bolt
Bolt assemblies
6
NOTE: Actual application may vary slightly from illustrations.
assemblies.
Nerf bar
Figure 6
Figure 4
tighten only at this point.
Figure 5
Repeat Step 6 to attach the nerf bar at the middle and rear bracket
7
Page 3 of 4
locations.
Figure 7
Publicidad
Tabla de contenido
