Kit Preparation; Kit Assembly - Metra Electronics 99-7377B Instrucciones De Instalación

Kit Preparation

1. Attach the (2) panel clips to the
radio trim panel as shown.
(Figure A)
Continue to Kit Assembly
(Figure A)
99-7377B
ISO DIN radio provision with pocket
1. Attach the pocket to the radio
brackets using the (4) #8 x 3/8"
Phillips screws provided. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the bracket/
pocket assembly and then secure it
using the screws supplied with the
radio. (Figure B)
4. Locate the factory wiring harness
and connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter
from Metra and/or Axxess. Test the
radio for proper operation.
5. Secure the completed assembly into
the dash using the factory screws.
6. Snap the radio trim panel over the
completed assembly, and then
reassemble the dash in reverse
order of disassembly.
3

Kit Assembly

(Figure A)
(Figure B)