Removing A Paper Jam; Operator Interface - Intimus 2051 SmartFold Instrucciones De Uso

Custom Folding Jobs
Custom Paper Lengths
To specify a custom paper length, press the Custom
Paper Length button. Using the number buttons,
enter a valid paper size value and press the Enter
button to save this value. When the message displayed
reads either "Folder Ready", or "Bypass Ready", you may
begin folding.
Custom Fold Table Settings
At this time, the folder enters a "manual" mode where you
must specify everything manually including Fold Table set-
tings, the Stack Wheel location, and the Paper Length. You
may use the pre-programmed paper sizes, if you wish.
When the folder is in manual mode, the "Other" light for
"SIZE SELECT" will be illuminated. To set a Fold Table
using the number buttons enter the desired fold position, and
then press the Enter button.
Custom Stack Wheel Location
See Stack Wheel Position.
Custom Fold Programs
The folder can store up to 10 different custom fold configura-
tions. Custom programs store Fold Table locations, Paper
Length, Quantity, and Batch Quantity. The location of the Stack
Wheels is calculated automatically when the program is
recalled. Folder speed is not stored as part of a program.
This button will "store" the current folder configuration
into a memory location.
This button will "recall" a previously stored folder con-
figuration.
Fold
Types
(8)

Operator Interface

Memory
Display
Control
Paper Sizes
Fold Select
Programs are maintained in memory even if the power is turned
off or power is removed. Once a program is stored into a mem-
ory location, it can not be deleted. Programs can only be over-
written with another program.
Storing a Program
To store a program, press the "Store" button, then press one of the
number buttons (0-9) to specify a storage location.
Recalling a Program
To recall a stored program, press the "Recall" button and then press
a number button where a program is stored. If there is a stored pro-
gram in the number pressed, the folder will immediately begin to con-
figure itself per the stored program. All of the standard Fold Table
and Stack Wheel messages will be displayed.

Removing a paper jam

1 Remove both fold tables.
2 Open the top cover.
3 Depress the feed
table to the load posi-
tion.
4 Take the "T" handle
from the storage com-
partment.
5 Insert the "T" handle
into the de-jam port.
6 Rotate the "T" handle
while pulling on the
paper jam.
! Warning: Don't use the machine, while you are working with
the "T"-Handle!
Incremental
Adjustment
Quantity
Size Select
Clear
Custom Paper
Entry
Length
2nd Fold
Stack
Table
Wheels
Display
Enter Contrast
Test
1st Fold
Table
Folder
Speed
Run
Stop