VITO AGRO Manual De Instrucciones página 52

EN
The following is a list of the maintenance that must be performed on the machine. Most of the items are described in
the Maintenance section. The user must only carry out the maintenance and service work described in this Operator's
Manual. More extensive work must be carried out by an authorized service workshop.
Maintenance
Clean the outside of the machine
Check that the harness is not damaged.
Make sure the throttle trigger lock and the throttle function correctly
from a safety point of view.
Check that the handle and handlebar are undamaged and secured correctly.
Check that the stop switch works correctly.
Check that the cutting attachment does not rotate at idle.
Clean the air filter. Replace if necessary.
Check that the guard is undamaged and not cracked. Replace the guard
if it has been exposed to impact or is cracked.
Check that the blade is correctly centred, is sharp, and is not cracked.
An off-centre blade will cause vibration that could result in damage to
the machine.
Check that the trimmer head is undamaged and not cracked. Replace
the trimmer head if necessary.
Check that the locking nut of the cutting equipment is tighten correctly.
Check that the transport guard for the blade is intact and that it can be
secured correctly.
Check that nuts and screws are tight.
Check that there are no fuel leaks from the engine, tank or fuel lines.
Check the starter and starter cord.
Check that the vibration damping elements are not damaged.
Clean the outside of the spark plug. Remove it and check the electrode
gap. Adjust the gap to 0,6-0,7 mm or replace the spark plug. Check
that the spark plug is fitted with a suppressor.
Clean the outside of the carburetor and the space around it.
Check that the bevel gear is filled three-quarters full with lubricant. Fill
if necessary using special grease.
Check the fuel filter from contamination and the fuel hose from cracks
or other defects. Replace if necessary.
Check all cables and connections.
Check the clutch, clutch springs and the clutch drum for wear. Replace
if necessary by an authorized service workshop.
Replace the spark plug. Check that the spark plug is fitted with a
suppressor.
DECLARATION
52
Daily Weekly
maintenance maintenance
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Monthly
maintenance
x
x
x
x