ASROCK Z97 Pro4 Manual De Instrucciones página 27

Tabla de contenido

Publicidad

USB 3.0 Header
(19-pin USB3_4_5)
(see p.1, No. 8)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 27)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to con-
nect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 19)
Chassis and Power Fan
Connectors
(4-pin CHA_FAN1)
(see p.1, No. 16)
(3-pin CHA_FAN2)
(see p.1, No. 29)
Vbus
Vbus
Vbus
IntA_PB_SSRX-
IntA_PB_SSRX+
IntA_PA_SSRX-
IntA_PA_SSRX+
GND
IntA_PB_SSTX-
GND
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND
IntA_PB_D-
IntA_PA_D-
IntA_PB_D+
IntA_PA_D+
Dummy
1
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
DUMMY
SPEAKER
1
+5V
DUMMY
FAN_SPEED_CONTROL
4
FAN_SPEED
3
+ 12V
2
GN D
1
CHA_FAN_SPEED
FAN_VOLTAGE
GND
Besides four USB 3.0
ports on the I/O panel,
there is one header on this
motherboard. Each USB
3.0 header can support
two ports.
This header is for
connecting audio devices
to the front audio panel.
Please connect the chassis
speaker to this header.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
Z97 Pro4
25

Publicidad

Tabla de contenido
loading

Tabla de contenido