Tools You Will Need; Mounting Space - GE APPLIANCES JVM3160DFBB Manual De Instrucciones

TOOLS YOU WILL NEED

#1 and #2
Phillips
screwdriver
Tin snips (for cutting
damper, if required)
Gloves
Safety goggles

MOUNTING SPACE

16-
1 2
from the floor
to the top of
the oven
6
Installation Instructions
Pencil
Scissors (to cut
template, if necessary)
Saw (saber, hole or keyhole)
Level
Bottom edge of
cabinet needs
more from the
cooking surface
min.
2
Backsplash
Ruler or tape measure and
straight edge
Electric drill with
3 16 7 16
1 2 5 8
Stud
Hammer (optional)
finder
NOTES:
•
and free of obstructions.
• This oven is for installation over ranges up to
• If the space between the cabinets is greater than
30", a Filler Panel Kit may be used to fill in the gap
between the microwave oven and the cabinets. Your
Owner's Manual contains the kit number for your
model.
• If you are going to vent your oven to the outside, see
Hood Exhaust Section for exhaust duct preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions on the
top cabinet template for power cord clearance.
• * 13" max: for standard installation, 15" cabinet
depth requires additional steps using an additional
installation kit JX15BUMPWW/BB.
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the vent.
• Café branded over-the-range microwaves should only
be installed over Café branded ranges. Installation over
any other range may result in surface temperatures that
can cause burns.
• All other over-the-range microwaves should not be
installed over any cooktop or range with a combined
BTU greater than 60,000 BTU.
Carpenter square
(optional)
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Duct and masking
tape
31-7000091 Rev. 2