Kohler K-1244 Diagrama De Instalación página 2

63-1/2"
(161.3 cm)
36-5/8" (93 cm)
36-5/8"
(93 cm)
30"
(76.2 cm)
Product Information
Mexico products have an M after the first sequence of
numbers (such as K-12345M).
Applicable product:
Bath with airjets, with
drop-in flange
Bath with airjets, with
tile-in flange
Fixture:* basin area
Bathing well 50" (127 cm) x
42" (106.7 cm)
water depth
To overflow 14-1/2"
(36.8 cm)
* Approximate measurements for comparison only.
Blower Heater
motor:
1 Hp 300 W
Included component:
Cutout template
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor:
Blower motor is supplied with a 24" (61 cm) grounding-type
plug-in cord.
1040127-1-B
60" (152.4 cm)
4-7/8"
(12.4 cm)
11-3/4"
(29.8 cm)
K-1244-G shown
K-1244-GTF flange detail
shown
top area
60" (152.4 cm) x
46" (116.8 cm)
capacity
102 gal.
(386.1 L)
Voltage Frequency
120 V 60 Hz
113925-7
120 V, 15 A, 60 Hz
30"
(76.2 cm)
42-1/2" (108 cm)
Blower Access
20" (50.8 cm) W x
15" (38.1 cm) H
19-1/2"
21"
(49.5 cm)
(53.3 cm)
1-1/4" (3.2 cm)
Notes
Install this product according to the installation guide.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.
Floor support under bath must provide for a minimum of 80
lbs/square foot (390 kg/square meter).
A blower motor access panel is required.
If installing a rim-mount faucet, make sure there is no interference
with drain overflow and circulating system before drilling any
weight
holes. Consult local and national codes for minimum air gap
119 lbs. requirements if installing a spout on the faucet deck.
(54 kg)
If used, the optional apron must be installed before the finish floor
and wall materials are installed.
Amperage
5 A
2
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
Recommended faucet area.
1-1/4"
(3.2 cm)
1/2" R.
(1.3 cm)
Integral Flange
Detail
1-1/2"O.D.
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
2-7/8" (7.3 cm)
3" (7.6 cm)
Kohler Co.