Rear Panel - R&S ZVA-Z75 Manual De Instrucciones

®
R&S ZVA-Z75, -Z90, -Z110, -Z140, -Z170, -Z220, -Z325, -Z500
screw after calibration, the power calibration is still valid but the system error correction
has to be repeated.

2.3 Rear Panel

The rear panel of the frequency converter provides the connectors and control ele-
ments described below:
●
Standby Switch
●
Power Supply Connector
●
Fuse Holder
●
RF Connectors – Input
●
RF Connectors – Output
Figure 2-3: Rear view of the frequency converter
2.3.1 Standby Switch
The standby toggle switch connects (ready state) or disconnects (standby state) the
internal modules of the frequency converter from the power supply.
A green light-emitting diode (LED) next to the switch indicates that the instrument is in
ready state. An orange LED further to the right indicates that the instrument is in
standby state. These LEDs are only lit when the converter is properly connected to the
power supply and the fuse of the instrument is intact.
Getting Started 1307.7039.62 ─ 11
Preparing for Use
Rear Panel
8