2" Pan Head Screw - Sauder 425299 Instrucciones De Uso

Step 10
å
1 -Carefully stand your unit upright against the wall in its final location. Strike a mark through the center of the hole in
st
the tab in the WALL POST (J). Move your unit away from the mark.
å
2 -Drill a 5/16" hole on the mark.
nd
å
3 -While you squeeze the wings together, gently tap one WALL ANCHOR (4) into the hole until it is even with the
rd
surface of the wall.
å
Place the tab in the WALL POST (J) over the WALL ANCHOR (4).
å
Turn one 2" PAN HEAD SCREW (7) through the hole in the WALL POST (J) and into the WALL ANCHOR (4).
å
NOTE: You will need to turn the SCREW (7) multiple turns to completely tighten and secure your unit to the wall.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
Mark and drill a 5/16"
hole into the wall.
2
nd
4
3
rd
J
1
st
7

2" PAN HEAD SCREW

(1 used in this step)
Page 15