Installation Steps - FOTILE SD2F-P1X Manual De Operación

Installation steps

Step 1: Unpack the unit. Take out the dishwasher from the carton and place it on a temporary
level and sturdy surface
Step 2: Install water inlet
Connect the inlet hose with 3/8" interface to the joint of the water inlet valve and screw it
together.
Step 3: Install accessories
1. Take out the rubber hose from the packaging bag and insert one end of the rubber hose
into the drip hole under the electrical lock.
2. Put the clamp into the upper end of the electrical lock tee, insert the electrical lock tee into
the drop opening of the overflow seat for the functional sink, and lock the clamp.
3. Insert the other end of the rubber hose into the electrical lock tee.
-8-
4. Put the clamp into the upper end of the overflow base - exhaust tee, insert the joint pipe
of overflow seat and insert the exhaust tee into the drip hole of the overflow base for the
sink, then put the overflow base into the exhaust tee, and lock the clamp.
5. Put the clamp into one end of the exhaust pipe, insert into the side hole of the exhaust
tee, and lock the clamp.
6. Connect and pre-tighten the drain hose assembly for the functional sink and the drain
opening of the functional sink. Ensure there is a gasket at the joint.
-9-