"Suction" Function - ARDES AR4A12 Folleto De Instrucciones

2. Place the cover (9) on the container (5) and close the locking clip (4).
3. "SUCTION" FUNCTION: connect the flexible metal hose (7) to the suction connection
(8)
"BLOW" FUNCTION: connect the flexible metal hose (7) to the blow connection (2).
Note - insert the hose fitting in the guides on the relative connection (2 or 8) and turn it
clockwise to lock it in place.
4. "SUCTION" FUNCTION: Make sure that the material to be sucked up has cooled down.
Note – be careful because it may be cool on the outside but still hot on the inside and,
when it comes in contact with the air, it may become incandescent again.
5. Position the aluminium pipe (6) near the material to be sucked up or blown.
6. Make sure that the switch (10) is set to "0", then insert the plug in the power outlet.
7. Turn on the unit by turning the switch (10) to position "I".
8. "SUCTION" FUNCTION: Suck up the ash using the aluminium pipe (6).
"BLOW" FUNCTION: direct the aluminium pipe (6) towards the material to be blown.
9. After use, turn the unit off by turning the switch (10) to position "0".
10. Remove the plug from the power outlet.
11. Remove the flexible hose by turning the fitting counter-clockwise. Empty out the
container (9), clean the filter (11) and the hoses (6 + 7) as indicated in the
"MAINTENANCE" paragraph.
NOTE: it is advisable to carry out the cleaning operations outdoors
Disconnect the plug from the power outlet before performing any cleaning and
maintenance operation.
Disconnect the hose (7) by turning it counter-clockwise, open the locking clip (4), remove
the cover (9) and remove the filter (11).
- Empty out the container (5) and, if necessary, wash it with water.
- Empty out the hoses (6-7) and, if necessary, wash them with water.
- Clean the filter (11):
o after each use, shake the filter and remove any dust residues using a brush;
o after several uses, if the suction power seems to have reduced, wash the filter
with cold water only, then let it dry completely before putting it back in place
(do not use dryers or other means).
Note: washing in water gradually deteriorates the filter. If, after washing the
filter, the suction power still seems reduced, replace the filter.
Reassemble the parts on the unit only when completely dry.
- To clean the unit externally, use a soft and slightly damp cloth.
Do not use overly wet substances, liquids or cloths, because any infiltration could
damage the unit irreparably.
Do not use alcohol or chemicals to clean the unit and the filter.
NEVER SOAK THE UNIT IN WATER.
MAINTENANCE
8 / 24