"Suction" Function - ARDES AR4A20 Folleto De Instrucciones

Note – the filter must be removed and cleaned after each use.
2. Install the fabric filter (16) on top of the HEPA filter, making sure that it covers it
completely.
Note – the filter must be removed and cleaned after each use.
3. Place the cover (4) on the container (10) and close the locking clip (9).
4. "SUCTION" FUNCTION: connect the flexible metal hose (6) to the suction connection
(5)
"BLOW" FUNCTION: connect the flexible metal hose (6) to the blow connection (17).
Note - insert the hose fitting in the guides on the relative connection (5 or 17) and turn it
clockwise to lock it in place.
5. "SUCTION" FUNCTION: Make sure that the material to be sucked up has cooled down.
Note – be careful because it may be cool on the outside but still hot on the inside and,
when it comes in contact with the air, it may become incandescent again.
6. Position the aluminium pipe (7) near the material to be sucked up or blown.
7. Make sure that the switch (2) is set to "0", then insert the plug in the power outlet.
8. Turn on the unit by turning the switch (2) to position "I".
9. "SUCTION" FUNCTION: Suck up the ash using the aluminium pipe (7).
NOTE: if the suction power decreases during use, perform the following operations: with
the unit on, press the dusk shaking button 5 times (8) with the aluminium pipe (7), waiting
2-3 seconds before pressing each time (see figure 3 at the end of the booklet).
If the suction power does not improve, it is necessary to switch the unit off, disconnect
it from the power supply and clean the filters (see MAINTENANCE).
"BLOW" FUNCTION: direct the aluminium pipe (7) towards the material to be blown.
10. After use, turn the unit off by turning the switch (2) to position "0".
11. Remove the plug from the power outlet.
12. Remove the flexible hose by turning the fitting counter-clockwise. Empty out the
container (10), clean the filters (14 + 16) and the hoses (6 + 7) as indicated in the
"Maintenance" paragraph.
NOTE: it is advisable to carry out the cleaning operations outdoors
Disconnect the plug from the power outlet before performing any cleaning and
maintenance operation.
Disconnect the hose (6) by turning it counter-clockwise, open the locking clip (9), remove
the cover (4) and remove the filters (14-16).
- Empty out the container (10) and, if necessary, wash it with water.
- Empty out the hoses (6-7) and, if necessary, wash them with water.
- Clean the filters (14-16):
o after each use, shake the filters and remove any dust residues using a brush;
o after several uses, if the suction power seems to have reduced, wash the filters
with cold water only, then let them dry completely (24h for HEPA filter) before
putting it back in place (do not use dryers or other means).
Note: washing in water gradually deteriorates the filters. If, after washing the
filters, the suction power still seems reduced, replace the filters.
Reassemble the parts on the unit only when completely dry.
- To clean the unit externally, use a soft and slightly damp cloth.
Do not use overly wet substances, liquids or cloths, because any infiltration could
damage the unit irreparably.
Do not use alcohol or chemicals to clean the unit and the filters.
NEVER SOAK THE UNIT IN WATER.
MAINTENANCE
8 / 27