Sebson SDL_FLEXIBLE_C Instrucciones De Manejo página 4

immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the
first start-up an and check the content for completeness!
Intended use:
This socket light of the brand SEBSON can be operated at any standard socket. Due to the flexible light head, the
light beam can be aligned as desired.
Scope of delivery:

1 Socket lamp
General safety information:
Danger:
In case of damages or contact with water turn off this product immediately without tension and make sure
that a restart is no longer possible!
Danger of suffocation:
that can be swallowed!
Caution:
Set up the light beam of the light never directly at people or animals to prevent fire damage or eyes
damage and avoid looking directly into the light source!

Operate this product at a suitable power outlet (230V AC 50Hz).

The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer
be guaranteed if it is modified! In addition, this will invalidate the warranty claim!

Do not connect a dimmer as this may cause a damage to the lamp. As a result of a strong heat
development the LED can be damaged!

Do not cover the light with heat insulating materials! As a result of a strong heat development the LED can
be damaged!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.

Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!

In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Start up (Fig.2):
Connect the socket light to a socket outlet that corresponds to the specifications (see technical data). After a short
warm-up phase of a few seconds, the device can be switched on as follows:
Press 1x: lowest brightness
Press 2x: middle brightness
Press 3x: highest brightness
Press 4x: OFF
Keep this product away from children and animals! The packaging contains small parts

An exchange of the built-in luminous in the light is not possible!
4