Precautions with regard to setting up
WARNING
Installation and removal should only be carried out by a qualified technician.
• If the bracket is installed incorrectly, the display may fall down and personal injury may result.
Make sure that all safety factors regarding strength of installation are observed.
• If the installation strength is insufficient, the display may fall down and personal injury may
result.
Do not install in places which are unable to bear loads.
• If the strength of the installation surface is insufficient, the display may fall down and personal
injury may result.
CAUTION
Do not install in places which are subject to humidity, dust, oil fumes, water vapour or
excessive heat.
• These can have adverse effects on Plasma Display operation, and fire or electric shocks may
result.
Do not install the Plasma Display face up, sideways or upside down.
• Doing so may cause heat to build up inside the display, and fire may result.
Two people are required to install and remove the display.
• If two people are not present, the display may be dropped, and personal injury may result.
Maintain a space of at least 10 cm ( ( 3
display, and at least 7.5 cm (2
• The display has ventilation outlet holes on the rear, and ventilation inlet holes on the bottom,
sides and rear. Covering these may result in a fire.
/
inches) ) at the top, bottom and sides of the
15
16
/
inches) at the rear of the display.
61
64
7