Replacement Parts - Kask PLASMA AQ Uso Y Cuidado

EN
HELMET ADJUSTMENT: Put on the helmet by rotating the rear dial (clockwise
to tighten and counter-clockwise to enlarge) and/or simply (only for the
versions with this system) by approaching the two elements of the fast closing
system until you obtain the desired fit (Fig. 2). Position the size adjustment
system in the zone of the nape (Fig. 3), inclining it and (only for the versions
with this system) regulating it in height. Close the strap by inserting one side
of the buckle into the other, until you hear the blocking mechanism click shut
(Fig. 4). Tug to check that the buckle is secure. Adjust the length of the neck
strap to fit the helmet securely to your head. The rubber ring should be placed
at the end of the strap to keep it from dangling. Adjust the side spacer, moving
it along the strap until it reaches the desired position (Fig. 5). To remove the
helmet, open the neckstrap by pushing both side buttons on the buckle at the
same time (Fig. 4).
REPLACEMENT PARTS: If necessary, contact the dealer or contact the
manufacturer directly. None of the original components of the helmet may be
changed and/or removed without the manufacturer's approval. The helmet
should not be modified to attach any accessories except for those described
below.
ACCESSORIES: Winter padding - face shield - sahariana - adapter for earmuffs.
Check with the dealer or manufacturer whether the accessories listed above
are available. If they are supplied with the helmet, follow the mounting
instructions that come with the accessory. Only accessories approved by the
manufacturer should be used.
CLEANING: Clean the helmet (and acessories, if applicable) only with
water, neutral pH soap, and a soft, clean cloth, allowing it to air dry at room
temperature. If it is removable, it can be removed and washed by hand in cold
water or in the washing machine (max. 30°C). In no case should chemical
detergents or solvents be used.
STORAGE: When not in use, the helmet should be stored away from direct
sunlight and sources of heat, and we recommend putting it back in the original
package. Do not apply adhesives, solvents, stickers, or paint that do not
comply with the manufacturer's specifications. Any alteration or intervention
not provided for may impair its protective function.
TRANSPORT: Given the type of device (helmet), no particular instructions are
necessary for its transport.