ESYLUX Mobil-PDi-Universal Manual De Instrucciones página 25

6 • OVERVIEW OF GENERAL FUNCTIONS
When you start up the Mobil-PDi/MDi-Universal, the default programme appears on the display: Mobil-PDi/MDi.
Then, the most recently selected remote control is indicated.
1
PDi/MDi
Remote control
3
Functions
Channel 1
Channel 2
5
System
7
Bat ok LS
1. Default programme of the currently selected remote control
(Mobil-PDi/MDi)
2. Remote control selection
3. Direct control of detectors without programming mode
4. Read mode for setting parameters
5. Information on Mobil-PDi/MDi-Universal
6. Currently selected remote control
7. Battery status ("ok"/"low")
8. Light sensor status
2
4
6
MDi
8
System
Switch off remote cont.
2
Software
Light sensor
4
Display brightness
Version no.
Bat ok LS
1. Remote control can be switched off manually, switches off
automatically if no button is pressed for approx. 60 sec
2. When an SD card is inserted, the various versions are
displayed in the respective language. If no SD card is inserted,
the following message appears: "Searching for SD card..." /
"no SD or file found"
3. Switching the light sensor ON/OFF
4. Adjusting the display brightness
5. Latest software version no.
GB
1
3
5
MDi
25