Care, Cleaning And Maintenance; Spare Parts - GPO 8x32 Manual De Instrucciones

Care, cleaning and maintenance

You can clean the optics of your product with the optical
micro-fiber cleaning cloth provided with your product, or by using
other lens cleaning equipment solely intended for optical cleaning
purposes.
Be sure to keep the optical surfaces clean and immediately remove
any dirt or oil debris caused by grease (finger prints), oil or water
spots to guarantee consistent optical quality.
To clean the exterior lenses of your product, be sure to first remove
any granular dirt or debris that may cause scratching during the
cleaning process. Be aware that rough granular dirt particles must
be removed with either an air bellows or a clean hair brush. Other-
wise, this may lead to damage of the optical coating or scratches
on your lens. Once large debris is removed, slightly breath onto
the optical surfaces to create a damp fog, then use the dry optical
cleaning micro-fiber cloth provided to clean the lens surfaces. All
other outside mechanical parts, as well as the rubber armor, can be
cleaned with a normal soft, clean and slightly damp cloth. Please
do not use the optical cleaning micro-fiber cloth to clean the out-
side parts or the rubber armor. This micro-fiber cloth must remain
free of any physical granular debris.
Proper strorage
After using the binocular it is recommended to store it dry, in the
case that came with your product, in a well-ventilated room, at
normal to low humidity levels, in normal room temperatures.
If you use your product in a region with high humidity, store your
product in an airtight container with a humidity absorption aid to
avoid any exterior fungus adhesion

Spare parts

If you need spare parts or accessories for your binocular, please
contact an authorized dealer or GPO GmbH & Co. KG.
EN