Components
Carefully remove all contents from packaging
and inspect the product to make sure all
components of the recliner have been received.
These should include:
A. Recliner frame with seat cushion
B. Back Cushion with hand control attached
C. Ottoman base
D. Ottoman support legs
E. Ottoman cushion
F. Arm rest pads
G. AC adaptor plug
H. Six 1.5"L screws for the arm rests
I. Four 7/8" screws for the ottoman cushion
B
F
A
F
G
H
I
J. Two 2" screws for the back cushion arm
supports
K. Two castle bolts to secure the back cushion
and seat together
L. Two castle pins to secure the back cushion
and seat together
M. Four large washers to be used in the
ottoman base
N. Two wrenches, one large and one small
O. Wooden caps for armrests
P . Four 1.75" Screws for ottoman base
Q. Six small washers for the armrests
E
D
C
J
L
N
K
M
O
4
Assembly Instructions
1. Attach the back cushion to the seat cushion
• Align the back cushion (B) support eyelets with the seat
cushion (A) eyelets. (Fig 1.)
• Insert the two castle bolts (K), one at a time, into the eyelets.
• Secure the pin through the bolt (L), making sure the pins
are pushed all the way in and snap into place.
• Attach the cover from the back cushion to the seat bottom,
covering up the bolts.
• Now that the seat and back cushions are secured, it's time
to secure the back cushion bolts to the arm rests.
• Line up the arm bolts to the arm rests holes. (Fig 2.)
• Insert both of the seat cushion connector bolts (J) and
tighten with wrench (N) only when both bolts have
been inserted.
• Cover the two-connector bolt holes with wooden covers
(O). Snap into place, or tap lightly with a rubber hammer
taking precaution not to damage the wood.
• Align armrests (F) to the wood frame, making sure they are flush
with the shape of the arm. Secure each armrest with three
screws (H) and insert all three screws before tightening to make
sure they all align properly. (Fig 3.) Tighten with large wrench (N).
Figure 1
P
Q
Figure 2
Figure 3
5