Kohler K-2338 Guia De Instalacion página 5

Hanger
Bolts
Mark anchoring
holes.
Apply adhesive
gaskets.
Pedestal and Lavatory Placement
2. Install the Lavatory
Drill 1/4" mounting holes at the marked locations on the finished
wall and the floor.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts to the backing material so they extend 1"
(2.5 cm) between the cap nut and the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Move the pedestal over the drilled hole in the floor, and secure
the pedestal to the floor by carefully tightening the wood screw
and washer.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the cap nuts and washers to the hanger bolts. Check the
level of the lavatory, and carefully tighten the cap nuts until snug.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Kohler Co.
Install faucet
and drain.
Pedestal
Finished Wall
5
Washer
Cap Nut
1033753-2-A