Cleaning And Maintenance; Check And Clean - Hunter Eco-Silver Manual Del Propietário

CLEANING AND MAINTENANCE

CHECK AND CLEAN

It is necessary to periodically check your Air Purifier for performance. If the
Eco-Silver and or the Permanent HEPAtech filters are covered with dust and
other particles, it will be necessary to replace the Eco-Silver pre-filter; and
either clean or replace the main HEPAtech main filter. The Eco-Silver pre-filter
is recommended to be checked once a month.
NOTE: Some indoor environments may require more frequent checking and
replacing of the Eco-Silver pre-filter. It might also be necessary to either clean
or replace the HEPAtech main filter.
1. Switch off and disconnect the air purifier from the supply socket.
2. Press the rear grille lock & release button down and remove the rear grille.
3. Remove the pre-filter and or HEPAtech filter from the air purifier.
4. Clean the HEPAtech main filter by using the vacuum brush attachment of
your vacuum cleaner gently. This will remove lint and dirt from HEPAtech filter.
An arrow indicating which side to clean is present on the label of the HEPAtech
filter. If the Eco-Silver pre-filter is covered with a heavy amount of dust and
particles, it will need to be replaced with a new Eco-Silver pre-filter to insure full
bacterial protection.
5. After cleaning or replacing of the filters, put the Eco-Silver pre-filter back onto
the rear grille and HEPAtech main filter back to the air purifier, then put back
the rear grille in place to the air purifier.
6. Use a clean, dry, soft cloth to wipe the external surface of the air purifier.
NOTE: Filter discoloration is normal and will not be removed by vacuuming. DO
NOT attempt to wash the filter as damage to the filter or air purifier may occur.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc., as they
will damage the product. NEVER use ALCOHOL OR SOLVENTS.
9