Kobalt KKC 0040-06 Manual De Instrucciones página 22

OPERATING INSTRUCTIONS
2
Loosen the screw
Load two AAA(1.5V) batteries
3. Using remote control
This remote has a memory function which requires a one-time pairing to the kid car. There is no need
to pair your remote each time the kid car is used, your remote will stayed paired after the initial
pairing, and when batteries are removed and replaced.
a.Press and hold the forward and reverse buttons at the same time, holding for 3 seconds. You will
then see the bottom red LED indicator light flashing.
b.Press the kid car power button and turn on. You will see a red light which signals a successful
pairing of your remote to the kid car.
c.After 10 seconds the remote control goes into "standby" mode, in order to continue you can press
any button.
d.Button Description: "▲'' Forward, ''▼'' Reverse, " " Left, '' '' Right, "S" Speed, "P" Stop. Press the
"S" button to set the speed. The bottom LED light indicator is the low-speed setting, the middle LED
light indicator is medium-speed, the top LED light indicator is high-speed. Press the "P" button to
brake, the LED light indicator will flash. Press the "P" button again to release the brake.
3
Forward
Speed
Reverse
21
Speed LED Light Indicator
Stop
Right
Code
Left