Publicidad
Idiomas disponibles
Idiomas disponibles
π
H-6502
FM APPROVED
ROTARY DRUM PUMP
TOOLS NEEDED
7/16" (11 mm) Wrench
Pump Type
Flow
Maximum Fluid Temperature
Bung Adapter
Suction Tube Length
Inlet
Outlet
Wetted Parts
Maximum Viscosity
IMPORTANT! This pump is made out of cast iron, steel, graphite, paper and polypropylene. Use liquids
compatible with pump component materials. Follow OSHA guidelines when using this pump, including proper
grounding and protective gear as required. For a full list of materials and compatible chemicals, see uline.com.
Unit not UL approved.
1.
Rotate handle clockwise several times to prime. Unit
will begin to dispense in less than seven strokes.
2. After using pump, position handle straight down.
Liquid will drain back into the container.
PAGE 1 OF 6
1-800-295-5510
uline.com
Adjustable Wrench
SPECIFICATIONS
OPERATION
Rotary – Vane
10 GPM
250°F
2" Male
40" Maximum
3/4" O.D.
3/4" O.D. Curved Spout
Cast Iron, Steel, Graphite, Paper, Polypropylene
400 cps
3. If pump is removed from drum, rinse it thoroughly in
a liquid that is compatible with both the pump and
the fluid being pumped.
4. Regularly check pump and suction tubes for leaks.
Leaks in the suction line or in pump housing will
cause inefficient pumping and loss of prime.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
0721 IH-6502
Publicidad
Tabla de contenido
Manuales relacionados para Uline H-6502
Resumen de contenidos para Uline H-6502
- Página 1 IMPORTANT! This pump is made out of cast iron, steel, graphite, paper and polypropylene. Use liquids compatible with pump component materials. Follow OSHA guidelines when using this pump, including proper grounding and protective gear as required. For a full list of materials and compatible chemicals, see uline.com. Unit not UL approved.
-
Página 2: Assembly And Installation
(7). drum. Once bottom of telescoping suction tube 4. Screw discharge spout assembly (2) into threaded touches base of drum, screw bung (20) into drum outlet of pump housing. fitting and tighten. 1-800-295-5510 uline.com PAGE 2 OF 6 0721 IH-6502... -
Página 3: Bomba Giratoria Para Tambos Aprobada Por Fm
Para la lista completa de materiales y productos químicos compatibles, vea uline.mx. La unidad no está aprobada por UL. 1. Gire varias veces el asa en el sentido de las 3. -
Página 4: Ensamble E Instalación
4. Atornille el ensamble de la boquilla de descarga (2) fondo del tambo, atornille el tapón (20) dentro del en la salida roscada de la carcasa de la bomba. tambo ajustando y apretándolo. 800-295-5510 uline.mx PAGE 4 OF 6 0721 IH-6502... - Página 5 Observez les directives de l'OSHA lors de l'utilisation de la pompe, y compris la mise à la terre appropriée et le port d'équipement de protection nécessaire. Pour une liste complète de matières et de produits chimiques compatibles, veuillez visiter uline.ca. La pompe n'est pas homologuée UL.
-
Página 6: Montage Et Installation
4. Vissez l'ensemble du bec de déversement (2) dans que le tube d'aspiration téléscopique aura touché la sortie filetée du boîtier de la pompe. le fond du baril, vissez la bonde (20) au raccord du baril et serrez. 1-800-295-5510 uline.ca PAGE 6 OF 6 0721 IH-6502...