Start-Up; Cold Starts; Restarting A Warm Engine; Idle Speed - MADER HHGT-001B Manual Del Usuario

START-UP

The controls required to start and run the tiller are located on the engine and are marked "choke"
and "Throttle".
A more detailed description of engine operation and all related precautions and procedures can be
found in the engine manufacturer's manual that accompanies each tiller.

Cold Starts

1. Move choke lever to full choke position.
2. Move throttle lever to "start".
3. Pull starting rope out slowly one time and allow to return normally.
4. Pull starting rope out rapidly, and allow rope to return normally.
5. When engine starts, gradually move choke lever to "no choke" position and increase the
throttle speed.

Restarting a Warm Engine

Restarting an engine that is already warm from previous running does not normally require use of the
choke.
1. Move throttle lever to "start" position.
2. Pull starting rope out rapidly until engine starts. Allow rope to return normally. Repeat until
engine starts.
3. Adjust throttle speed to "high"' for best tiller action.

IDLE SPEED

Use the "low" position on the throttle lever to reduce stress on the engine when tilling is not being
performed.
Lowering the engine speed to "idle" will help extend the life of the motor, as well as conserve fuel
and reduce the noise level of the equipment.
WARNING!
Temperature of muffler and nearby areas may exceed 150°F. Avoid these areas.
Do not move choke control to choke to stop engine. Backfire or engine damage
may occur. To stop wheels and tines at any time, release drive safety control levers
to neutral position. Always release drive safety control levers to neutral position
before adjusting the depth of the regulator lever.

OPERATING SPEED

For normal tilling, set the throttle lever to "fast."
77