MADER HHGT-001B Manual Del Usuario página 90

PROBLEM
Belts squeal when in neutral and/or
reverse
Belts squeal while in forward mode
Excessive heat build-up in
transmission/tine area during tilling
REMEDY/ACTION
* Adjust the forward belt guide:
- Turn the engine off and allow the
muffler to cool.
- Disconnect the spark plug wire and
secure it from the spark plug.
- Remove the belt guard.
- Pull down on the drive safety
control levers.
- Manually ben forward the belt
guide and the belt.
- Replace the belt guard and the
spark plug wire.
* Adjust the tabs on the reverse belt guide.
- Turn the engine off and allow the
muffler to cool.
- Disconnect the spark plug wire and
secure it from the spark plug.
- Release the drive safety control
levers to neutral position.
- Remove the belt guard.
- Adjust the tabs of the reverse
belt guide; while the drive safety
control levers are released, bend
the metal tabs on the reverse belt
guide to 1/64 inch or less clearance
from the reverse belt.
- Replace the belt guard and the
spark plug wire.
* Remove vegetation by following the
instructions in Clean Tine Axle Shaft of
Normal care section.
FOLLOW ALL SAFETY INSTRUCTIONS
* Check the transmission fluid and fill if
needed.
90