Installation; Preparing For Installation; Installing The Escutcheon - Glacier bay HD67622X-5001 Guía De Instalación Y Cuidado

Installation

1

Preparing for installation

CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet. Clean the surface in preparation for
the new faucet.
□
Loosen the set screw (B) pre-assembled to the
spout (A) with the Hex wrench (Hex: 2.5mm, J),
rotate the spout (A) about 90° to face the spout
(A) towards the front, then tighten the set screw
(B) with the Hex wrench (Hex: 2.5mm, J).
A
2
A
J
B
4

Installing the escutcheon

□
Place the escutcheon (E) over the standpipe (D)
and push it to the base.
E
D