Task 9: Creating Disk Arrays With Webpam Proe - Promise Technology VessRaid 1740s Guia De Inicio Rapido

Task 9: Creating Disk Arrays with WebPAM PROe

Setting up disk arrays with WebPAM PROe consists of the following actions:
• Logging into WebPAM PROe (below)
• Selecting a Language (page 25)
• Creating a Disk Array (page 25)
• Logging out of WebPAM PROe (page 29)
Logging into WebPAM PROe
1. Launch your Browser.
2. In the Browser address field, type the IP address of the VessRAID
subsystem.
Use the IP address you obtained in Task 7 (see page 19 or 19). Note that the
IP address shown below is only an example. The IP address you type into
your browser will be different.
Regular Connection
• WebPAM PROe uses an HTTP connection. . . . . . . . . . . . . . . .http://
• Enter the VessRAID's IP address . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
http://192.168.10.85
Secure Connection
• WebPAM PROe uses a secure HTTP connection . . . . . . . . . .https://
• Enter the VessRAID's IP address . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
https://192.168.10.85
You can also use the CLU to create disk arrays and logical drives.
See Chapter 5 of the VessRAID Product Manual for more
information.
Whether you select a regular or a secure connection, your login to
WebPAM PROe and your user password are always secure.
Task 9: Creating Disk Arrays with WebPAM PROe
Note
Note
23