ShopMaster DELTA S36-269 Manual De Instrucciones página 10

2. The support plates can be raised to act as positive
stops when cutting multiple boards to the same
length. See Figure 8 & 8a.
3. Adjust support rods as needed and tighten lock
knobs as shown in Figure 9 & 9a.
4. This stand is equipped with one adjustable foot to
level stand on surfaces that may be less than level.
Adjust as needed to stabilize stand. See Figure 10 &
10a.
To avoid risk or serious injury, do not
attempt to use stand if it cannot be
placed in a stable level position.
ADJUSTMENT INSTRUCTIONS
FIGURE 8
LOCK
KNOB
FIGURE 9
FIGURE 10
10
a
TIGHTEN
a
TIGHTEN
a