Power Connector Introduction; Installation Steps - Thermaltake Toughpower Grand Manual Del Usuario

Toughpower Grand
3.

Power Connector Introduction

P/N
Cable
Main Power Connector (24Pin)
EPS/ATX 12V Connector (4+4PIN)
EPS 12V Connector (8Pin)
Peripheral Connector (4Pin)
FDD Connector (4Pin)
SATA Connector (5P)
PCI-E Connector (8P)
PCI-E Connector (6P)
Connector Type
MODELS
24pin
EPS/ATX 12V 4+4pin
EPS 12V 8pin
Molex & FDD
650W
750W
SATA
PCI-E 6pin
PCI-E 8pin
PCI-E 8pin to 6pin adapter
03
TPG-650M TPG-750M
650W 750W
1 1
1 1
1 1
8 8
1 1
8 8
2 2
2 2
Connectors & Cable length
1 x 24pin Main connector
(550mm)
1 x EPS/ATX 12V 4+4pin connector
(550mm)
1 x EPS 12V 8pin connector
(550mm)
4 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm + 150mm + 150mm)
4 x Peripheral
(500mm + 150mm + 150mm + 150mm)
4 x S-ATA connectors
(500mm + 150mm + 150mm+ 150mm)
4 x S-ATA connectors
(500mm + 150mm + 150mm + 150mm)
2 x 6pin PCI-E connectors
(500mm)
2 x 8pin PCI-E connectors
(500mm)
2 x 8pin to 6pin PCI-E adapter
(150mm)
Toughpower Grand

4. Installation Steps

Note: Make sure that your system is turned off and unplugged.
Note: Make sure that your system is turned off and unplugged.
Disconnect the AC power cord from your old power supply.
Disconnect the AC power cord from your old power supply.
1. Install the PSU into the case with the four screws provided.
Include the two vibration absorbent gaskets (recommended)
that come with the unit.
2. Connect the 24-pin Main Power
Connector to your motherboard.
04