Air Supply - Total TAT20751 Instrucciones De Uso

Air supply

1. Use clean, Dry and Regulated compressed air at 4-7 bar (60-100psi)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would cause
noise, fast-worn or misfiring.
3. When connecting air supply always keep hands and body from discharge area of tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as possible.(see
fig 4.)
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction
in power and efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the hose if
possible.
7.
Be sure all connections in air supply system are sealed to prevent air loss.
Operating Instruction
Using the Washing Gun
1. Connect the washing gun to air compressor via suitable hose.
2. Pour some appropriate amount of neutral detergent or hydrolytic thinner into the container.
3. Connect gun body with container tightly and aim the nozzle to parts what you want to clean.
4. Adjustment of fluid.
5. Drain,clean and dry the solvent chamber after use and before storage.
Warning: Avoid the use of highly inflammable solvents. Do not use to spray petrol. Non
flammable commercial degreasers and detergents should be used. Never use
corrosive detergent nozzle with thinner.
6. Pour remaining detergent into another container and clean detergent passage and fluid
container.
7. Using the soft clothes with some thinner clean the washing gun body and the surface of
CAUTION:
Never use corrosive detergent or homogenate hydrocarbon solvent washing machinery parts or clean washing gun,
which can chemically react with aluminum and ironic parts or chemically compatible with aluminum and ironic parts.
3