How To Use Remote Control - Hisense AE-15K4AF1 Operación Manual

How to use remote control

Signaling window
Smart
Send signals to host of
Press the Smart button
air purifier.
to run in smart purify
mode.
Timer button
Set the timer function
Set shutdown time when the
machine is on -1h-
4h-8h
Set startup time when the
machine stands by -1h-
4h-8h
(Timer startup and shutdown
is unavailable at the same
time)
Mute
Press the mute button to run
in mute mode.
Tips
When you use this remote for
Manual
remove the isolation plastic paper
In manual mode, adjust
purify mode and purify
The battery used on this remote control is
speed manually.
the remote control has been used
months, or if the remote control does not work properly,
Purify speed
please replace the battery
In smart purify, mute and
sleep mode, this button is When
disenabled. However, in
installation direction of positive and negative electrodes,
manual mode, the speed
is cycled in Low - Middle - as shown in the figure below on the left.
High - Turbo order.
Disposal of battery: please remove the battery when not
in use for a long time. When the battery is used up,
Anion
discard the battery in a recycling unit.
Press anion button to
Placement of remote control: the remote control contains
enable anion function. Press
this button again to
magnets and can be closely attached to back of the
disenable anion function.
machine, as shown in the figure on the right.
Sleep
Press the sleep button to
run in sleep mode.
ON/OFF button
Press this button to turn the
air purifier on, and press it
again to stop.
In standby mode, press this
button to start up and run in
last operating state.
the first time, please
from button battery.
continuously for
in time.
replacing the battery, pay attention to correct
of CR2025. If
six