Philips 1000 Serie Manual De Instrucciones página 3

5 Place the beard trimming comb attachment
on the skin and move the appliance slowly
over the beard.
Tips:
- When you trim your beard for the first time,
start at the highest hair length setting and
reduce the hair length setting gradually.
- To trim in the most effective way, move
the appliance against the direction of hair
growth. (Fig. 13)
- Do not move the appliance too fast. Make
smooth and gentle movements. Make sure the
flat surface of the comb attachment always
stays in contact with the skin.
- Regularly remove cut hair from the comb
attachment. If a lot of hair has accumulated in
the comb attachment, remove the comb from
the appliance and blow and/or shake the hair
out of it.
Trimming at the unique 'stubble look
setting'
1 To create a 'stubble look', trim with the beard
trimming comb attachment set to hair length
setting 1. (Fig. 14)
Trimming without the beard trimming
comb attachment
Use the appliance without beard trimming comb
attachment to trim and contour your beard and
remove single hairs.
1 To remove the comb attachment, press the
adjustment button (1) and pull the comb
attachment off the appliance (2). (Fig. 8)
2 Make well-controlled movements and touch
the hair lightly with the cutting element.
Note: To contour your beard, hold the appliance with
the cutting element pointing upwards (Fig. 15).
Cleaning
Do not use abrasives, scourers, compressed air or
liquids such as alcohol, petrol or acetone to clean
the appliance.
Only clean the appliance and the adapter with the
brush supplied.
Do not use any sharp objects to clean the
appliance.
Clean the appliance after every use.
1 Make sure the appliance is switched off
and disconnected from the mains before
you clean it.
2 To remove the comb attachment, press the
adjustment button (1) and pull the comb
attachment off the appliance (2). (Fig. 8)
3 Clean the cutting element and the hair
removal groove behind the cutting element
with the brush supplied (Fig. 16).
Note: The cutting element cannot be detached and
the appliance cannot be opened.
The appliance does not need any lubrication.
Replacement
Only the adapter, the hair trimming comb
attachment and the beard trimming comb
attachment are replaceable.
Environment
- Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 17).
- The built-in rechargeable battery contains
substances that may pollute the environment.
4203.000.5742.3
Always remove the battery before you
discard and hand in the appliance at an official
collection point. Dispose of the battery at an
official collection point for batteries. If you have
trouble removing the battery, you can also take
the appliance to a Philips service centre. The
staff of this centre will remove the battery for
you and will dispose of it in an environmentally
safe way (Fig. 18).
Removing the battery
Only remove the battery when you discard the
appliance. Make sure the battery is completely
empty when you remove it.
Do not connect the appliance to the mains again
after the battery has been removed.
1 Disconnect the appliance from the mains and
let the appliance run until the motor stops.
2 Insert a screwdriver into the opening in
the bottom of the appliance. Then move
the screwdriver upwards to open the
housing (Fig. 19).
3 Pry the battery out of the appliance.
4 Cut the wires close to the battery with a
pair of household scissors and dispose of the
battery properly.
Guarantee and service
If you need service or information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If
there is no Consumer Care Centre in your country,
go to your local Philips dealer.
3/9