camry Premium CR 4410 Manual De Uso página 4

17. To provide additional protection, it is advisable to install a residual
current device (RCD) in the electric circuit with a rated residual current not
exceeding 30 mA. Ask an electrician for this advice.
18. Never use the device without water! It may be damaged.
19. Never direct a stream of hot steam or water towards your body.
20. Never use the device with sparkling water !!!
21. Never leave the device at a temperature below 0 degrees Celsius, as it
may damage it.
22. Always unplug the machine before filling the tank with water.
23. Regularly clean and inspect the machine to ensure the quality of coffee
obtained and to extend the life of the machine.
24. Always disconnect the power source before cleaning and allow all hot
parts to cool down. The device should be cleaned with a mild non-abrasive
detergent. Never use cleaning solvent as this could damage the paint
layer.
25. For descaling the machine, use a liquid descaler designed for pressure
coffee makers.
26. During use, never touch the filter housing or the milk frothing nozzle,
as there is a risk of burns.
27. Use only original accessories.
28. Do not move or move the device during operation.
This machine has a classic functions of Italian concentrated espresso and cappuccino coffee. Rich coffee aroma and foam, easy to
operate and safe, easy to clean.
PRODUCT DESCRIPTION: COFFEE MACHINE Cr4410
1. Auto Single Cup - button for automatic preparation of 1 cup of coffee
2. Auto Double Cup – button for automatic preparation of 2 cups of coffee
3. Power button
5. Steam button
7. Removable drip tray
9. Water tank 1600ml
11. Main housing
13. Steam nozzle
15. Filter handle
17. Filter housing
19. Light indicator
21. Unlock mark
23. Hot water function mark
Operating Instruction
Before using for the first time
After unpacking the device, check with are all the buttons available and the steam knob (10) turned off in the "OFF" position. Before
applying wipe the device (see Cleaning and maintenance).
1. Remove the water tank (9), pour water into water tank (9), the water level should not exceed the "MAX" mark. It is recommended to
use filtered water. This prevents lime build-up and improves the taste of the prepared coffee. Do not use soda water.
2. Run hot water twice (instructions below) to remove the factory new odor before first use.
3. Plug in and press the power button (3). At this time, the light indicator (19) flashes blue. Press the Manual Coffee Cup button (4) to
work the pump, pumping water from the water tank to the device for heating.
4. The device starts to preheat, at this time, the light indicator (19) flashes blue; when the blue light stops blinking and turns on
continuous blue lighting, the warm-up is completed, it takes about 2 minutes.
4. Manual Coffee Cup button
6. Drip grid
8. Water tank lid
10. Steam knob
12. Steam nozzle handle
14. Measuring spoon
16. Filter retaining clip
18. Filter for ground coffee for 1 cup
20. Funnel
22. Lock mark
24. Filter for ground coffee for 2 cups
4