Dimplex BLF7451 Manual Del Usuario página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
continue running before turning
off.
!
NOTE: The unit can be operated
in Heat Only Mode. When the unit
is only running with the heater,
the
icon will continuously
be displayed on the Floating
Display
.
TM
!
NOTE: The heater may emit a
slight, harmless odor when first
used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
D & E.
Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off to
maintain the desired set temperature.
The default temperature setting is
72°F (22°C).
→ Adjusted by pressing the
decrease the setpoint and the
to increase the setpoint on the unit
or the remote.
• The Floating Display
the temperature setpoint as it is
adjusted.
!
NOTE: Holding the
the
buttons down for two
seconds, on the manual controls,
to
will indicate
TM
and
will change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the season,
the heater on the unit can be
disabled. The unit will operate in the
same fashion, with remainder of the
controls.
Pressing the
on the manual controls at the same
time and holding for 2 seconds will
disable and enable the heater.
!
NOTE: When the heater has been
disabled and either the
the
is pressed the Floating
Display
will indicate "--".
TM
F.
Color Themes
Different presets of ambient lighting
color combinations contained in the
unit.
→ Changed by repeatedly pressing
the corresponding button on the
remote or the unit.
• Cycles through the different
preset ambient lighting settings
of the unit, this includes different
combinations of colours of the
flame base and media lighting.
!
NOTE: The last theme of the cycle
is a prism where the unit cycles
through a variety of colours.
Pressing the
and
buttons
or
button stops the
15

Publicidad

Tabla de contenido
loading

Tabla de contenido