Step 4: Print A Network Setup Page - Lexmark MarkNet N2000 Serie Referencia Rápida

Step 4: Print a
network setup
page
6
To set the address, netmask, or gateway:
a
Press
Menu
b
Press
Select
c
Press
Select
Saved appears briefly.
7
Press to return the printer to the Ready state.
Go
Use the printer operator panel to print a network setup page to verify
your IP settings.
1
Press until you see Utilities, and then press
Menu
2
Press until you see Print Net1 Setup (or Print Net2
Menu
Setup), and then press
3
Look under the TCP/IP heading on the network setup page to
verify that your IP address, netmask, and gateway settings are
non zero.
The printer returns to the Ready state.
5
to increase (or decrease) each number.
to move to the next segment.
again when you are finished. The message
.
Select
.
Select