Publicidad
Place each twisted wirenut in the junction
box. Then align the floodlight camera base
on the junction box so that it's oriented
correctly.
Place 2 #8x1-1/2in screws through the base
and into the the mounting holes on the
junction box. Screw the base firmly in place.
Mount the floodlight camera to the
5
base and junction box.
Plug the 3-wire connector
back into the floodlight
camera base
as shown.
Make sure it's
completely
seated before
proceeding.
Floodlight camera, front
Base screws
Turn on power to your floodlight's
6
circuit
Turn the breaker that controls
the circuit for your floodlight
back on.
Confirm the floodlight camera has
7
power
At first power up, the floodlights come on.
Once the floodlight camera is ready for setup,
the floodlights turn off and the indicator on the
front of the camera flashes blue and red.
Note: If you've installed the floodlight camera
on a switchable outlet, you might need to turn
the switch on.
Place the floodlight
camera over the base so
that the base's mounting
tabs fit into the camera's
slots. Find the 3 base
screws you removed in
step 3. Put the base screws
back into their slots and
tighten completely.
5
Publicidad
