Maytronics 2010 Manual Del Usuario página 4

Setting the Automatic Mode
To Change the Automatic Mode settings
First press the Manual/Automatic select button, then set according to the following table:
Cleaning cycle
indicator
This determines
the cleaning cycle
time. The RCU
allows you to
choose between
the following
options.
Delay Time
indicator
This determines
when the pool
cleaner starts to
work.
A delay allows the
dirt to settle to the
bottom of the pool.
Cleaning action
indicator
Allowing you to
choose from the
following options.
Note:
•
After 2 minutes, if no button is pressed, the Remote Control Unit will shut-down and the
Pool cleaner will continue to work in the previous settings
•
When the "Ultra-Clean" and "Walls Only" options finish their cycles, the RCU will return
to default settings.
Fast Efficient
. 2.5 hour cycle for
1.5 hour cycle
everyday use.
(Default setting
Immediate start One Hour delay
(Default setting)
Standard Ultra-clean
Stronger suction
Floor and wall
cleaning. and slower
(Default setting) movement
Floor and cove
cleaning only.
Extra
3.5 hour cycle
)
Two Hours delay
Floor only
Cleans only the
floor and coves.
3
.
Walls Only
Cleans walls and
waterline only.