Technical Information - ARDES 595 Manual De Instrucciones

The appliance has been designed and manufactured to operate in the
home. Any other use is considered inappropriate and dangerous.
Do not use the appliance out of doors.
Do not let any object into the ventilation inlets of the appliance.
During use, rest the appliance on a flat surface.
Keep the appliance 50cm from the wall or any other obstacle.
Always empty the tank before moving the appliance.

Technical information

1 - Control panel.
2 - Directional louver.
3 - Hand grip.
4 - Filter grille.
5 - Water drain.
6 - Tank.
This product has been manufactured in conformity with current
2006/95/EC and 2004/108/EC.
Regulation (EC) N.842/2006:
R134a is a type of fluorinated greenhouse gas covered by the Kyoto
Protocol.
Its global warming potential (GWP) is 1430.
Technical data: see the label on the back of the tank.
Instructions for use
ATTENTION: Do not tilt the appliance by more than 45° or turn it
upside down, whether it is stationary or being transported.
ATTENTION: Before turning on the appliance, let it settle for at
least two (2) hours after installation.
After you plug the appliance into the power outlet, press the ON/OFF
button.
The RUN indicator light will come on and the degree of humidity in the
room will appear on the display.
The 2 air intake speeds can be selected using the SPEED key: LOW
(slow) and HI (fast).
The HUM key can be used to set the desired degree of humidity: RH
50%, 60%, 70%, 80%, AU, CO.
Each time the HUM key is pressed, the corresponding value that can be
selected appears on the display. Once the selected humidity level has
been reached, the compressor turns off (RUN lamp flashing) and the fan
goes on working
8
Picture at pag.2
GB
GB